Ballindagny and Cullyvore

30 registered freehold parcels lie mostly in Ballindagny and Cullyvore, from 393 m² to 298,024 m² (29.8 ha, 73.64 acres). The dashed line is the townland's boundary. 19 neighbouring parcels touch it.

Download the townland as DXF, in Irish Transverse Mercator metres, with its boundary, parcels and buildings, or as GeoJSON or KML.

No zone of a development plan covers Ballindagny and Cullyvore in the national zoning. Outside zoned towns and villages, the county development plan's rural policies apply to each application.

Source: Tailte Éireann and the Department of Housing (MyPlan), national zoning, CC BY 4.0.

• 24 Feb 2017Conditional

  Construct a 5 bay double sheep shed and all ancillary site works

  Permission · Longford County Council, 1757

Source: National Planning Applications, Department of Housing, Local Government and Heritage, CC BY 4.0. Applicants are not shown.

Designated sites

No designated site (Special Area of Conservation, Special Protection Area, Natural Heritage Area or proposed one) touches the townland of Ballindagny and Cullyvore.

Recorded monuments

• LF015-060 Ringfort - rath
  Description

  On a NE-facing slope in pasture, c. 170m above a small but fast-flowing stream. A raised circular area (diam. 29.6m) enclosed by the outline of a levelled wide bank of earth and stone (Wth c. 7.6m), a wide, shallow, intervening fosse (Wth 5.4m; D 0.5m) and a wide low outer bank (Wth 6.55m; H 0.1m). From WSW–W–N the external face of the outer bank has been destroyed due to the construction of a modern NE–SW field boundary. The original entrance is not recognisable. Compiled by: Patrick F. O'Donovan Date of upload: 23 November 2011

• LF020-006 Enclosure
  Description

  At the base of a low-lying WSW-facing slope in pasture. A report in 1976 (SMR file) indicates that this roughly trapezoidal-shaped, raised area (c. 41m NW-SE; c. 30m NE-SW) was then defined by a bank of earth and stone and an external fosse. It is now defined by a scarp (H 0.5-0.7m) and is divided into unequal portions by a modern NW-SE field bank and drain. The smaller portion, to the NE, has been levelled and is not visible at ground level. Spoil from the excavation of the drain has been piled up adjacent to the SW side of the field boundary. The original entrance is not recognisable. Compiled by: Patrick F. O'Donovan Date of upload: 26 August 2011

Architectural heritage

• Holy Well Bridge, bridge, 1760–1800 · Regional interest
  Description

  Single-arch road bridge over stream/river, built c. 1780, with squared rubble limestone walls/spandrels and parapets and having a round arch with dressed limestone voussoirs. Located to the southwest of Edgeworthstown.

Designated sites: National Parks and Wildlife Service. Recorded monuments: Sites and Monuments Record, National Monuments Service. Buildings: National Inventory of Architectural Heritage. Department of Housing, Local Government and Heritage, CC BY 4.0. Works at or in relation to a recorded monument need two months' written notice to the National Monuments Service (National Monuments (Amendment) Act 1994, section 12).

Radon

At the centre of the townland of Ballindagny and Cullyvore, about 1 in 10 homes in this area is likely to have high radon levels. Testing a home

Landslides

The 1:50,000 map rates the landslide susceptibility here as moderately low, low, partly inferred.

Terrain model

LiDAR of the Office of Public Works, flown in 2011, at 2 m: tile OPW_1844 (ZIP).

Flooding

The Office of Public Works publishes its flood maps on floodinfo.ie.

Radon Risk Map of Ireland, Environmental Protection Agency, and Landslide Susceptibility Classification, Geological Survey Ireland, both under CC BY 4.0. LiDAR: contains Irish Public Sector Data (Geological Survey Ireland & the Office of Public Works) licensed under a Creative Commons Attribution 4.0 International (CC BY 4.0) licence.

No address of the register names Ballindagny and Cullyvore with five sales or more. The sales of the area are on the page of Co. Longford.

Name

Ballindagny and Cullyvore · Baile an Deagánaigh agus An Chúil Mhór

Area

1,173,123 m² (117.31 ha, 289.89 acres)

Civil parish

Mostrim, and its townlands

Barony

Ardagh

Electoral division

Meathas Truim, the unit of the census

Census 2022

2,477 people lived in 844 households in the Meathas Truim electoral division. 46% of households owned their home. 59% of homes were built since 2001. 13% of dwellings stood vacant on census night, and 2% were holiday homes.

Neighbouring townlands

Abbey Land, Ballinree and Ballymoat, Camlisk Beg, Lackan, Shantum, Tinnynarr

Placenames

Ballindagny and Cullyvore on logainm.ie, the Placenames Database of Ireland

Townlands, civil parishes, baronies and electoral divisions, National Statutory Boundaries, Tailte Éireann, CC BY 4.0. Census 2022, Small Area Population Statistics by electoral division, Central Statistics Office, CC BY 4.0. A townland is the smallest land division of Ireland, and the unit of a rural address. Old registers such as the 1901 and 1911 censuses file it under its civil parish and barony.