Culloge

11 registered freehold parcels lie mostly in Culloge, from 1,464 m² to 141,091 m² (14.11 ha, 34.86 acres). The dashed line is the townland's boundary. 13 neighbouring parcels touch it.

Download the townland as DXF, in Irish Transverse Mercator metres, with its boundary, parcels and buildings, or as GeoJSON or KML.

No zone of a development plan covers Culloge in the national zoning. Outside zoned towns and villages, the county development plan's rural policies apply to each application.

Source: Tailte Éireann and the Department of Housing (MyPlan), national zoning, CC BY 4.0.

• 9 Jun 2026Conditional

  RED III Application for a 10-year planning permission with a total site area of 3.13 hectares. The development, an amendment to the previously granted development Ref: 2360010 will consist of: • The construction of one Enercon E138 Wind Energy Converter on an 99m tower with an electrical rating of 4.5MW and an overall tip height of 169m; • An amendment to substation design, changing from a block-built to a modular design comprising of 2 single-story prefabricated modules surrounded by stock proof fencing; an ESB module measuring 14.33 m² and height of 3.41m and; an IPP module measuring 33.31 m² and 3.89m in height; and• All associated ancillary works including, access tracks, drainage electrical ducting and reinstatement works. The operational lifespan of the development will be 35 years from the date of commercial operation. This planning application is not subject to a Natura Impact Statement (NIS) or Environmental Impact Assessment Report (EIAR). This development is covered by the provisions of the Renewable Energy Directive III (Directive (EU) 2023/2413) and it is important to note that the planning application may be subject to section 34D of the Planning and Development Act 2000, as amended. When a notice issues in accordance with section 34D(b), the provisions of article 26A of the Planning and Development Regulations 2001 to 2025 shall apply

  Permission · Longford County Council, 2660181

• 19 Apr 2023Conditional

  the construction of one Enercon E138 Wind Energy Converter on an 81m tower with an electrical rating of 4.2MW and an overall tip height of 149.38m. Installation of the hardstanding area for the Wind Energy Converter. Installation of underground circuit cables which will run in underground cable trenches (c.1.2m deep), from the proposed Wind Energy Converter to the proposed substation building on the site. Construction of the proposed substation building which will be located c. 98m from the proposed wind turbine and surrounded by stock proof fencing. It will be a single storey building, measuring 55m2 and c.4.8m in height. Construction of proposed internal site access track, constructed from permeable material and which will run from the site entrance to the Wind Energy Converter hardstanding area. All associated ancillary infrastructure and preparatory works such as provision of the site entrance

  Permission · Longford County Council, 2360010

• 31 Jul 2019Conditional

  proposed change of house design from a storey & a half type dwelling house with detached garage, entrance, boundary fence/wall, proprietary wastewater treatment unit with percolation area all of which was previously granted full planning permission under Planning Reference Number PL16/220 to a dormer bungalow type dwelling house with detached garage & which is proposed to be serviced via the previously permitted entrance, boundary wall/fence, proprietary wastewater treatment unit with percolation area and all ancillary works

  Permission · Longford County Council, 19205

Source: National Planning Applications, Department of Housing, Local Government and Heritage, CC BY 4.0. Applicants are not shown.

Designated sites

No designated site (Special Area of Conservation, Special Protection Area, Natural Heritage Area or proposed one) touches the townland of Culloge.

Recorded monuments

• LF015-064 Ringfort - rath
  Description

  On a gentle SSE-facing slope in pasture. Not indicated on the 1837 or 1887 eds. of the OS 6-inch map. A raised circular area (diam. 36.9m) enclosed by a low bank of earth and stone (Wth 4m; H 0.4m max.) with a shallow external fosse (Wth 3.4m; D 0.3m). It is divided into roughly equal portions by a NE-SW roadway, field bank and drain. The rath has been levelled to the NW of these but its outline may still be traced. The original entrance is not recognisable. Compiled by: Patrick F. O'Donovan Date of upload: 26 August 2011

• LF015-066 Ringfort - rath
  Description

  On a hillock in pasture. A raised circular area (diam. 31.8m) enclosed by a partially denuded low bank of earth and stone (Wth 4.5m; H 0.9m max.) with a shallow external fosse (Wth 3.7m; D 0.2m). From NNE-E-ESE the fosse has been modified where it is bordered by a modern NW-SE field bank and drain. A break (Wth 2.9m) in the bank at ENE with traces of a possible accompanying causeway may mark the original entrance. Compiled by: Patrick F. O'Donovan Date of upload: 26 August 2011

Architectural heritage

No building of the National Inventory of Architectural Heritage stands in the townland of Culloge.

Designated sites: National Parks and Wildlife Service. Recorded monuments: Sites and Monuments Record, National Monuments Service. Buildings: National Inventory of Architectural Heritage. Department of Housing, Local Government and Heritage, CC BY 4.0. Works at or in relation to a recorded monument need two months' written notice to the National Monuments Service (National Monuments (Amendment) Act 1994, section 12).

Radon

At the centre of the townland of Culloge, about 1 in 10 homes in this area is likely to have high radon levels. Testing a home

Landslides

The 1:50,000 map rates the landslide susceptibility here as low, partly inferred.

Terrain model

No LiDAR survey of the Office of Public Works covers the centre of the townland of Culloge.

Flooding

The Office of Public Works publishes its flood maps on floodinfo.ie.

Radon Risk Map of Ireland, Environmental Protection Agency, and Landslide Susceptibility Classification, Geological Survey Ireland, both under CC BY 4.0. LiDAR: contains Irish Public Sector Data (Geological Survey Ireland & the Office of Public Works) licensed under a Creative Commons Attribution 4.0 International (CC BY 4.0) licence.

No address of the register names Culloge with five sales or more. The sales of the area are on the page of Co. Longford.

Name

Culloge · Collóg

Area

454,073 m² (45.41 ha, 112.2 acres)

Civil parish

Mostrim, and its townlands

Barony

Ardagh

Electoral division

Crosagstown, the unit of the census

Census 2022

260 people lived in 98 households in the Crosagstown electoral division. 90% of households owned their home. 28% of homes were built since 2001. 9% of dwellings stood vacant on census night, and 1% were holiday homes.

Neighbouring townlands

Cam, Curry, Lissanore, Longfield, Monadarragh, Rinnenny

Placenames

Culloge on logainm.ie, the Placenames Database of Ireland

Townlands, civil parishes, baronies and electoral divisions, National Statutory Boundaries, Tailte Éireann, CC BY 4.0. Census 2022, Small Area Population Statistics by electoral division, Central Statistics Office, CC BY 4.0. A townland is the smallest land division of Ireland, and the unit of a rural address. Old registers such as the 1901 and 1911 censuses file it under its civil parish and barony.